Forum: Charging Systems, Electrical & Solar
05-16-2008, 12:41 PM
|
Replies: 3
Views: 2,319
|
Forum: Charging Systems, Electrical & Solar
05-15-2008, 01:56 PM
|
Replies: 3
Views: 2,319
Wire
Hi, In the engine area of my 1974 I have two units on the driver side. One on each side of speedometer sending unit. They have hyd lines connnected to the bottom and wires on top. The one on the...
|
Forum: Charging Systems, Electrical & Solar
05-15-2008, 01:53 PM
|
Replies: 0
Views: 1,773
Wire
Hi, In the engine area of my 1974 I have two units on the driver side. One on each side of speedometer sending unit. They have hyd lines connnected to the bottom and wires on top. The one on the...
|
Forum: Exterior Works
05-12-2008, 11:07 PM
|
Replies: 0
Views: 2,684
Electrical
Hi everyone, I am going to get my 1974 completely debugged yet. In my engine area drivers side, I have 2 units,1 on each side of my speedometer sending unit. Thery are hooked to hyd lines on the...
|
Forum: Charging Systems, Electrical & Solar
05-12-2008, 10:18 PM
|
Replies: 1
Views: 2,519
|
Forum: Charging Systems, Electrical & Solar
05-12-2008, 03:51 AM
|
Replies: 1
Views: 2,519
Short
Hi bill moore again, I still have my problem it developed into a real short burnt up my merge relay. It leads to red button on back panel marked 70. What are these? There are two on these on back...
|
Forum: Major Mechanicals
05-10-2008, 03:59 PM
|
Replies: 3
Views: 3,034
John, I spoke to you awhile back I have a 1974...
John, I spoke to you awhile back I have a 1974 with 1160 engine and the problem I can't explain in writing. A broken wire in the engine area in front of the big air filter. Would you kindy call me....
|
Forum: Major Mechanicals
05-10-2008, 01:46 PM
|
Replies: 5
Views: 3,049
|
Forum: Charging Systems, Electrical & Solar
05-09-2008, 08:26 PM
|
Replies: 1
Views: 2,129
Hi this is Bill Moore, I solved my own...
Hi this is Bill Moore, I solved my own problem,the wires going into the converter had become slightly loose, probablly from vibration from the road. This was the most difficult problem in a motor...
|