Luxury Coach Lifestyles - View Single Post

RV Bummin · 10-04-2006, 02:19 AM

I have a 30K BTU furnace that just went out.
Diagnosis: I'll turn up the thermostat, the fan will come on and when it calls for heat; no click, no spark, no gas, it'll just shut down (total time of about 15-30 seconds). I'll re-set and the same thing happens. Everything worked fine for the previous days as I had the LP over half full and full charge. From my research (Here) I believe it's the board. Suggestions?

If it is the board, it sounds as though going with a Dinosaur replacement board is the way to go. Where is the best place to get one from?

Also, is this something that is best left for the service department, or easy enough to do myself?

Thanks in advance for your input!

10-04-2006, 02:19 AM	#1
RV Bummin New Member Join Date: Mar 2006 Posts: 6	Suburban furnace problem. I have a 30K BTU furnace that just went out. Diagnosis: I'll turn up the thermostat, the fan will come on and when it calls for heat; no click, no spark, no gas, it'll just shut down (total time of about 15-30 seconds). I'll re-set and the same thing happens. Everything worked fine for the previous days as I had the LP over half full and full charge. From my research (Here) I believe it's the board. Suggestions? If it is the board, it sounds as though going with a Dinosaur replacement board is the way to go. Where is the best place to get one from? Also, is this something that is best left for the service department, or easy enough to do myself? Thanks in advance for your input!