Tom, on April 28, you asked that I post how I installed Xantrex LinkPro. I installed the round monitor in the bulkhead above the microwave, facing the kitchen counter. I used computer ethernet cable (which has four twisted pairs), and ran it behind the microwave and pantry into the Aqua Hot compartment. Then I drilled a small hole into the battery compartment where I connected the shunt and wiring. So far, so good. It took me some study to figure out how to program the unit, but well worth it and now I can monitor the percent of charge left and am notified if I go down to 50%. I also installed and programed Tire Tracker to monitor all 12 tires. Will be in Phoenix next week so perhaps we will get a chance to chat.
|