Do's and Don'ts for Soundproofing Your Luxury Motor Coach or RV
[TABLE="class: cms_table"]
<tbody>[TR]
[TD] Do's
-
Read instructions
-
Plan carefully
-
Make templates first
-
Use sharp tools
-
Use only recommended adhesives with adequate ventilation
-
Apply 2 or more coats of adhesive to clean mounting surface
-
Apply adhesive for and install one panel at a time
-
Experiment with a test piece first
-
Allow adequate clearance (6" Minimum) from engine & exhaust manifolds
-
Seal all exposed surfaces with Seam tape
-
Protect wear points and contact surfaces with Seam tape
-
Use Fasteners as required
[/TD]
[TD="width: 50%"] Don'ts
-
Tear reflective foil covering
-
Apply too much adhesive
-
Use "Other" brand adhesives without testing first
-
Expose foam to bilge or wet areas
-
Expose materials to temperatures above 250 F
-
Leave exposed joints or edges
-
Rely on adhesives alone for permanent attachment
-
Leave gaps or openings in installed surfaces
-
Expect to completely eliminate all-noise
[/TD]
[/TR]
</tbody>[/TABLE]
__________________
Ken
Previous Owner of 3 Newell's
Wanted: Newell Coach Needing Engine Replacement!
If you want to sell, PM or Private Message me. Thanks!
"I know I’m not perfect, and I don't live to be. But before you start pointing fingers, make sure your hands are clean."
-Bob Marley
|