It's now been a few weeks and a few thousand miles..... I have continued to change the filter when it got full or almost full. It seems to go farther between changes and the last change was 500 miles ago. When I checked it today I was confused. It was either totally full of fuel or the level was below the clear plastic viewing area. I finally removed the cap on the top and determined that there was no fuel visible in the viewing area. The coach starts and runs normally. I am sure I stopped the dropping level of the fuel about an inch into the viewing area when I changed the filter last.
So, is there any way I can bring the level up into the viewing area short of removing the cap and just adding some fule that way?
Should I be concerned, or does the level sometimes go below where you can see if shortly after a filter change?
Thanks,
|