i gave gordon the wabco model number of the abs system and a few minutes later he sends me the troubleshooting manual for it.
i did as it says and entered the blink code fault indicator mode and it had no active faults and 2 stored faults. the first stored fault was drive axle drivers side sensor gap too much. the second was the ECU high power supply.
i then checked it again and got the same codes. then i reset it and the codes went away.
so now i need to see if they reappear when i drive it next.
i will see how to adjust the gap on the sensors and maybe have it doen when it is up on a lift next wednesday. the voltage i am sure is because i have been working with bad batteries and have been playing with the settings on the charger.
time will tell, but it is cool to figure it out.
thanks to all and thanks to gordon...
tom
|