If yours is in the same location as the early 1990's models, you are correct. The process on the early 90's models is:
Open passenger's side front compartment where the generator fan is located. Remove the 3 screws that hold the metal plate at the front corner of the bay and remove the metal plate. Slide out the wooden divider that has insulation glued to it. Remove the 3 screws that hold the metal base that the wooden divider was resting on to the compartment floor. Remove the screws from the lowest of the three panels at the front of the compartment and remove the vented plate. The expansion valve should now be accessible behind the vented plate. The two larger plates above cover the coils and the blower motors.
|