[Bikestuff]

There are two pieces. 1). The lock cylinder that has the key hole in it. Napa part number ks66491 and the ignition switch housing (holds the lock cylinder). Napa part number Ks6603.

To remove the switch housing first pull on the surrounding trim piece. It is held on by those little tree thingies.

Next you need the key in ignition. Locate the tiny hole next to where the key goes in. Put a paper clip in the hole and gently giggle the key. ( I am not sure if the key needs to be in position 0, 1, or 2. But you should be able to feel a little button depress. When you get it right, the entire lock cylinder along with the key will come out.

Now you should be able to spin off the bezel. Be sure to hold the back piece cause you could spin the wires on the back into a knot.

When the fron bezel comes loose, you will be able to extract the switch housing from the back. The wire connector is held on by a black tab on either side. (these tabs are tough to get loose so take your time)

I will follow up with a few pictures.

Cheers,

Bill