i spent 5 hours at the bus shop running the wires. i got them in a conduit ok no problem, but only from the engine compartment to just behind the front wheels. the is where the conduit comes out and i have not been able to figure out how to get the wires to the front so i can pull them behind the dash. i spent hours trying to figure out how.
fortunately i had the bus on a lift and could raise and lower it and get it where i needed it too, but my big bod doesnt like squating for hours at a time.
i am trying to run them in the channel from just to the drivers side frame rail next to the generator and from there through the channel some other lines are running up to just under the steering wheel where there is a hole in the floor to run the wires up too.
easier said than done.
hopefully they will let me use the lift again tomorrow nite.
i ran a black, green, red and white to each side of the engine bay and have them all tied up there ready to use for something. so 8 total.
just have to figure out the last couple of feet up front.
later
tom
|