[Richard and Rhonda]

My first rig had a Flexsteel loveseat for the drivers side. I did couple of things to make if fit better. One I put some foam in the back rest which scooted me forward on the seat. I put a good inch and half back there. That solved the short thigh problem. I then put some foam in the seat bottom, but I did not place it evenly across the width. I built up the sides to make bolsters so that the flat seat was now more like a bucket.

I didn't have to lower it in that rig. But I did lower the seat in the Newell. The way I did that was to remove the turntable under the seat. Both front seats have a turn table so that you can rotate them. I never used the driver seat like that and that lowered the seat an additional two inches. But that created a new problem. The left arm was now hitting the window console. It was simple to remove the arm.