[GORDON HUMMEL]

I've just added a few pictures of the microwave installed. The existing cabinet size was ok, but the black switch plate above it had to be cut down in height & also moved out to overlap the top of the new front panel. Also had to add a little spacer on the left, top & right. I usually won't make any changes unless it will look factory.
On my switch panel be careful as there is 110 ac to the water heater switch. Also the top of the new microwave bezel will have to be notched to allow the generator switch to fit. Also you'll want to add some electrical tape to the cut out you made, as I have found you might start the generator by mistake by touching the switch to the alum bezel !