[GORDON HUMMEL]

Jon,
You mentioned the bushing on the Ridewell suspension being a possible problem, so I'm assuming that is what you have. I found the tie-rod ends on my rear transverse torque rod to be worn out. Also the tie-rod end on my drag-link at the axle was bad. Both of this items caused wandering. Almost forgot, the wheel bearing on the right side were adjusted within specs, BUT was my problem. I think if you'll look on this side, you will see where I put my Newell on one of those shacking rigs & all was OK. My mechanic, raised the wheel, using a crow bar shocked the wheel & didn't like it. We pulled the wheel & all was OK. reassembled & he adjusted the bearing by hand, did a test drive & all was ok.