Battery Cable Gauge - Luxury Coach Lifestyles
Journey with Confidence RV GPS App RV Trip Planner RV LIFE Campground Reviews RV Maintenance Take a Speed Test Free 7 Day Trial ×
Reply
 
Thread Tools Display Modes
 
Old 09-26-2006, 03:49 AM   #1
Retired Phil
Member
 
Join Date: Dec 2005
Location: Houston, Tx
Posts: 36
Default Battery Cable Gauge

Does anyone know the average gauge size for a battery cable???

Phil
__________________

__________________
1989 Newell Coach

-Phil & Janice Wickham-
Retired Phil is offline   Reply With Quote
Old 09-26-2006, 01:57 PM   #2
fulltiming
Senior Member
 
fulltiming's Avatar
 
Join Date: Feb 2006
Location: Texas
Posts: 1,558
Default

1/0 is used in small 6 and 8 cylinder cars for the primary battery cables, 2/0 for diesel engines and 3/0 to 4/0 for heavy equipment engines.

When I had a new 2500 watt inverter installed in a previous motorhome, they used 00 gauge wire (also written 2/0) which has a diameter of 0.57". Larger diameter wire will result in less voltage loss over a longer distance.
__________________

__________________
Michael and Georgia Day
1992 Newell 43.5' #281
8V92 DDEC-2, HT740
PT Cruiser GT with Remco Transmission Pump
https://newellowner.com/newell-photos/
fulltiming is offline   Reply With Quote
Old 03-08-2009, 05:20 AM   #3
encantotom
Senior Member
 
encantotom's Avatar
 
Join Date: Mar 2007
Location: mesa, az
Posts: 1,375
Default

hi all,

i am gonna make some new battery cables. so are they 2/0 on our coaches?

i was thinking i was gonna need 3/0 or 4/0, but after looking at 2/0 cables i think that is what is on mine already.

i will go measure the outside diameter with a caliper and check for sure.

so is 2/0 ok for the coach and engine batteries?

thanks

tom
__________________
2002 45'8" Coach
2008 Honda CRV toad

https://www.newellclassic.com/forum/album.php?albumid=8
encantotom is offline   Reply With Quote
Old 03-08-2009, 03:56 PM   #4
JohnC
Member
 
Join Date: Aug 2006
Location: Grove Oklahoma
Posts: 89
Default

Rule of thumb #1 - The more copper the less the resistance

One of those rare instances where it's pretty hard to use too much

Rule of thumb #2- Keep all connections clean, especially the chassis ground. I can't begin to guess how many perfectly good starters and alternators have been replaced/rebuilt because of poor connections, especially chassis grounds. Removing the suspected unit often cleans the 'bad' connection, and then when the new unit corrects the problem, the incorrect diagnosis is assumed as right-on.

One quick method to check for bad grounds or loose connections is with a non-contact thermometer. While the better-half is cranking the engine, quickly check for heated connections. Resistance creates heat and loose connections will normally be much hotter then the rest. Same for cables- if your cables are getting fairly warm I would increase the size. You can also use the non-contact thermometer to check your shore power connections for heat, wheel bearing temps, restrictions in your radiator (cold spots), brakes dragging, tire temps etc. I keep one just inside my door and routinely check my tire temps everytime I stop at a rest area.
JohnC is offline   Reply With Quote
Old 03-09-2009, 03:49 PM   #5
prarieschooner
Senior Member
 
Join Date: Jan 2009
Location: Idyllwild, CA
Posts: 120
Default

Here is a link that may be helpful to you in selecting wire size. You will need to use a good Crimping Tool when you make the Cables up.
Hope that this is helpful;
http://www.westmarine.com/webapp/wcs...MarineWire.htm
__________________
Steve & Tricia
1982 Newell 38' Classic
DD 6V92
prarieschooner is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

» Featured Campgrounds

Reviews provided by

Powered by vBadvanced CMPS v3.2.3
Disclaimer:

This website is not affiliated with or endorsed by Newell Coach Corporation or any of its affiliates. This is an independent, unofficial site.


All times are GMT. The time now is 04:34 AM.


Powered by vBulletin® Version 3.8.8 Beta 4
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
×