Tuga, In my earlier post ( Original problem ) it was same part angle iron 90 Degree bracket , this one was under the slide room frame , I did not see it since I was working while my wife was watching them fix it!it happened due to lifing the front longes slideout, since then I bought some 6x4 stock wood and have two massive pump jacks , if my seal ever pup out I will be set to lif it, I remember whenthe newell serviced our slide due to fluid line burst , they had two big jacks and they ajcked up both sides even , I think that is the best way to do it and avoiding bending any parts inside! but again i dont know for sure!
Will run the engine today and slide outs and will wax it under slides ( NASCAR drivers trick on Newells slides ) than some windex and powder! You got to baby thet slide! haha!! Happy Holidays everyone!
|