[jmacstack]

I just received my 9280. After looking at the narrow bay that it will go in to replace the boiler, the task feels a bit daunting. I have to change the electrical receptacle because mine doesn't accept the 9280's blade configuration. That's easy. My breakers are all 20 amp so I should be fine just changing the receptacle. The part that seems the hardest is the giant junction box right in front of the current charger as well as the shore power cord rack which are all in the way. I'm wondering from those who have stood in these shoes, did you have to remove the cord rack to gain better access to the bay? I am assuming that the only wire I have to add is an additional ground wire. I am planning on removing the old battery charger and putting the 9280 in its place. Any advice would be very helpful. I will try to post some pics of the current set-up. Thanks Again, Jennifer