[Bikestuff]

Exactly! I think the way that they did it was to first use VESA screws to put the small block on tv. Then screw from the back of the big mounting board into the smaller block. (just so you don't have to line up vesa screws through two layers). But as good as you are...there is probably a better way of doing the same thing.

The result was super easy, and super secure. Mine has about five screws on each side...and is more secure than the front one with the fancy struts.

Don't forget that you have to leave a port for the IR remote sensor. The old TV used the Niles system, but the new one just has a hole in the bezel.