 |
11-28-2010, 09:58 PM
|
#1
|
|
Member
Join Date: Mar 2010
Posts: 28
|
Aqua Hot Temp sensor
I bought a new temp sensor wile at the factory, didn't know why at the time, yesterday mine gave up. Does anyone know where it's located and how to change it,
__________________
__________________
Lee & Patsy Brown
98DS45L #476
Granbury TX
|
|
|
|
11-28-2010, 10:25 PM
|
#2
|
|
Senior Member
Join Date: May 2006
Location: Houma, LA
Posts: 886
|
__________________
__________________
Tuga & Karen Gaidry
1999 Newell 45 w/2 slides
Coach #512
2005 Pilot
|
|
|
|
|
11-28-2010, 11:33 PM
|
#3
|
|
Member
Join Date: Mar 2010
Posts: 28
|
Aqua hot temp sensor
thks Tuga, I checked out the site but it dosn't show the temp sensor, I'm told only Newell uses . the water temp gauge for the Aqua Hot system
__________________
Lee & Patsy Brown
98DS45L #476
Granbury TX
|
|
|
|
|
11-30-2010, 11:56 PM
|
#4
|
|
Senior Member
Join Date: Feb 2010
Posts: 433
|
Since you haven't gotten an answer, if it was me I would check with the Yahoo forum "Hydronic-RV-Heating". This site is moderated by Roger Berke who is very knowledgeable about the Aqua Hot systems and he is active in the forum. It is free to join the forum.
Hope this helps..................
__________________
Steve
Newell
|
|
|
|
|
12-01-2010, 12:32 AM
|
#5
|
|
Senior Member
Join Date: May 2006
Location: Houma, LA
Posts: 886
|
Lee,
Have you tried calling Newell? 1 888 963-9355 and ask for Tommy Key or Creslie Clark.
__________________
Tuga & Karen Gaidry
1999 Newell 45 w/2 slides
Coach #512
2005 Pilot
|
|
|
|
|
12-02-2010, 11:45 AM
|
#6
|
|
Senior Member
Join Date: Sep 2009
Location: Muskogee, OK USA
Posts: 208
|
Temp Sensor
batpilot7300,
There is a shiny plate about 5 inch's square just above where the diesel burner mounts to the tank. It is held in place by two screws, one on top and one on bottom. Behind this plate you will see the heating elements and the zone temp sensors. Above these there will be a brass nut 7/16" or 1/2" with three wires coming from it. one red, one black and one green. I believe this is the sensor you are looking for, it goes to the temp gauge above the microwave. Please remember to unplug your coach and have all heat shut off, your fingers will be very close to the wires on the heating elements.
Jeff
__________________
Jeff and Pam
1996 Newell 45'/Tag
60 Series Detroit
Coach #432
|
|
|
|
|
12-03-2010, 03:18 AM
|
#7
|
|
Senior Member
Join Date: May 2006
Location: Houma, LA
Posts: 886
|
batpilot7300,
If you are going to work on that Aqua Hot be sure to disconnect the 2 sets of wires that plug into the unit. They are located under the silver colored control box in the very front of the unit. It has Webasto logo written on it in RED. With both of those sets of wires disconnected you should be safe. The wires have a white plastic head that easily disconnects from the unit.
There are 8,000 volts of electricity that run between the 2 probes on the burner assembly.
Be careful!
Call Newell just to be safe 1 888 9NEWELL and let them walk you through it.
__________________
Tuga & Karen Gaidry
1999 Newell 45 w/2 slides
Coach #512
2005 Pilot
|
|
|
|
|
12-04-2010, 06:27 PM
|
#8
|
|
Member
Join Date: Mar 2010
Posts: 28
|
to all.....thanks for your help,
__________________
__________________
Lee & Patsy Brown
98DS45L #476
Granbury TX
|
|
|
|
|
| Thread Tools |
|
|
| Display Modes |
 Linear Mode
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Threads |
|
No Threads to Display.
|
|
