|
12-21-2011, 01:41 PM
|
#1
|
New Member
Join Date: Jan 2006
Location: Rhode Island
Posts: 2
|
79 Newell Repower
I am re-powering my 79 Newell. It had a 555 Cummins and I am replacing with a 6V93 Silver with 747HT Allison. My problem is top end RPM differential. The Detroit will not turn up as did the Cummins, so I need to change the gear ratio. I am thinking perhaps a 3:42 or 3:21, but don't like to guess. Anyone with a 6V92 and 4 spd Transmission who could advise me of the ratio in their Newell would be a great help. Thanks Rooster
__________________
|
|
|
12-22-2011, 11:56 PM
|
#2
|
Senior Member
Join Date: Oct 2007
Location: Huntington WV
Posts: 1,041
|
I would join over at http://www.busconversions.com/bbs/index.php?board=1.0
And post the question. Those guys are all over the repower biz.
__________________
__________________
Richard Rhonda Ty and Alex Entrekin
1995 Newell # 390 DD Series 60, Allison World Trans
Subaru Outback toad
CoMotion Tandem
Often wrong, but seldom in doubt
Rhonda's chronicle https://wersquared.wordpress.com/
|
|
|
12-23-2011, 02:04 AM
|
#3
|
Senior Member
Join Date: Jun 2009
Location: Idyllwild, CA
Posts: 1,340
|
Actually I would ask the guys at Newell. Our '82 has the 6v92 and they should be able to help with this question. I think that the '83 also had a 6V92.
I know how to check the ratio but I am a bit too lazy to jack the rear tires off of the ground to count the revolutions. I am just not sure what our ratio is otherwise I would be able to post it.
__________________
have Coach will Travel
Steve & Tricia
1982 Newell 38' (built before #1) 6V92 DD, 5 Speed Allison, 12.5 KW Kohler, Couch used to make into a Bed but I fixed it!
https://newellshowcase.com/thumbnails.php?album=214
2007 Yukon, 1981 CJ7 Laredo, 2002 Honda CRV, 1955 Thunderbird, 1952 Pontiac Sedan Delivery, 1952 Ford 8N, 1958 Airstream, 1959 Glasspar 16' Avalon, Cabin in the Woods........what will I work on next
[SIGPIC][/SIGPIC]
|
|
|
01-16-2012, 04:25 PM
|
#4
|
Senior Member
Join Date: May 2008
Location: Just North of Detroit, a surprizingly great city
Posts: 380
|
Calculating Rear Axle Gear Ratio
Gear ration calculations were a mystery to me until I was looking at the Michelin tire website and noticed their brochures list the revolutions per mile for each tire.
Figuring out the needed drive axle gear ratio is now fairly easy. The variables in the calculation are tire size, axle gear ratio, transmission ratio, and engine speed. The tire size and transmission ratio are fixed. The question is what engine RPM do you desire when traveling at 60MPH (one mile per minute is used for easy calculation).
First look up the revolutions per mile of the drive tires. Michelin shows that my 11R22.5 load range G tires rotate 502 times per mile. My transmission output in 4th gear (highest) is 1:1 of the engine speed. If I wanted the engine RPM to be 2000 at 60MPH then the needed drive axle gear ratio would be 2000/502=3.98. If I wanted an 1800RPM engine at 60MPH the gear ratio would be 1800/502=3.59. If you have overdrive or under-drive through the transmission you have to factor that into the calculation.
If you are going to change a ratio you will need to check that both your speedometer and RPM gauge are accurate or at least know how far off they are so any inaccuracies can be compensated for. Currently I show 2025RPM at 60 (which I've timed to really be about 62MPH). Since my speedometer is reading low I need to calculate what the RPM would be at 60MPH by multiplying the 2025 by the ratio of the speed difference 60/62. The ratio of the speed difference is 60/62=0.968. The engine RPM at a real 60MPH is 2025X0.968=1960. To get the 502 tire revolutions per mile while the engine is turning 1960 requires a 1960/502=3.90 gear ratio.
Hopefully this helps those concerned about drive axle ratios. If you can spot any adjustments needed with these calculations please post your comments here so everyone can learn.
Jon Kabbe
77 Coach repowered from 555 to 6V92T
2007 civic toad
|
|
|
|
Thread Tools |
|
Display Modes |
Linear Mode
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Threads |
No Threads to Display.
|
|