|
12-24-2012, 06:58 PM
|
#1
|
Member
Join Date: Aug 2012
Posts: 19
|
Hot water flow has slowed substantially in our newell coach
Although the cold water pressure has not changed at the faucets, the hot has slowed substantially. Any suggestions.
Thomas Lindsay
__________________
|
|
|
12-25-2012, 12:32 AM
|
#2
|
Senior Member
Join Date: Sep 2006
Location: Sugarland, TX or Salida,CO
Posts: 1,867
|
See your water heater check valves. the reduced flow on the 'hot' side of a faucet is usually due to some trapped 'crud' from the water heater tank finding it's way through the system.
In older rigs, if the water heater tank isn't flushed on a seasonal basis, small 'balls' of 'crud' may accumulate and then find their way downstream to the faucets
__________________
__________________
Sean
If Ain't a Newell, It Ain't Wurt Oonin!
|
|
|
12-26-2012, 03:06 AM
|
#3
|
Senior Member
Join Date: Dec 2007
Location: Armenia, Wisconsin
Posts: 278
|
If the mineral content of the water is high enough to cause severe crudding of the tank, you are going to get mineral slats throughout the water lines and faucet screens regardless. The heat in the hot lines makes it more susceptible, of course.
Flushing the tank and lines can only help, though. I do ours annually, though we do not seem to pick up a lot of crap in the tank. We have an inlet filter on the water system, but still have to clean the screens at the faucets once a year too.
__________________
1983 Newell Coach
|
|
|
12-26-2012, 05:05 PM
|
#4
|
Member
Join Date: Sep 2011
Posts: 82
|
Because of the hard water here out west where I live, With our newell I usually flushed the hot water system with a mild vinegar solution. I fill the water heater with a solution of about 2 or 3 gallons of vinegar. I then heat the solution and flush the hot system.
It's amazing how much crud comes out of the lines while doing this.
__________________
1977 Newell Classic
|
|
|
12-26-2012, 10:27 PM
|
#5
|
Member
Join Date: Dec 2012
Location: West Fargo, ND
Posts: 48
|
Might be as simple as adjusting the flow valves a bit. Mine has 1/4 turn valves on the inlet side, the output side, and one inline between the two to reduce the maximum temperature of the output by blending cold water with the hot water. If one or more valve is closed too much, the flow reduces significantly.
As noted by others, there may be crud in the lines too. If you open the valves for a second while water is flowing, any crud will be passed downstream to the next restriction. If the faucet handle is open all the way, the crud should pass through the handle and be caught by the aerator at the spout. That's easy to clean.
Vantare
__________________
1959 Corvette Convertible
Cannondale Slice 5 Bike
2006 Prevost Vantare’ Double Slide
Steve & Annie
|
|
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Threads |
|
|